thoughts on RT classic/mini combo

[rukh013]

so i've been seeking air-thru capability with a mag since i saw flatliners mag, but there seems to never be enough room, i threw around the idea of a mag with mini lowers and saw the idea pop up in a MotM entry...

so i have pics of my plans

here
and here

im able to fit without modification:
Humphrey CRCB-0053W
MPA-3
microline & fittings
LPR (all i have available is an AKA im SURE i can find a smaller one

plumbing illustration here

all this needs is a custom rail, sleeper asa, retreading the valve to 1/8 NPT. i was hoping to use the eye board from the mini (body milling required) and using a jumper to connect the lower and upper board, socketing the solenoid into the upper board and wiring a micro switch for trigger

this will be mostly reversable




so my question is where can i get a rail made to test a proto-type, i think this will be awesome?
Who wants one?

[Flatliner333]

Is the banjo bolt smaller than 1/8 npt? If so I would try and find a straight male to female fitting that would fit the hole in the valve without modification. Good luck I hope this works

[BTAutoMag]

I could probably make a fitting to use the existing banjo bolt and still convert it to 1/8 NPT...