I noticed that the C clip/washer was loose on one of my aftermarket bodies. Is this something I should be concerned about? It seems like the bolt spring would just hold it in place when the valve is installed.
-
How loose? If it can fall out, just pull it out, open it up a bit and lock it back into place. -
Ha, I am dumb, I didn't even think of taking it out, I was just going to leave it as is. I will take a look at it. thanksComment
-
Yeah, I wouldnt just leave it in place if it just flopping around in there. The spring should hold it in place, but if you'e not paying attention you could shove the valve in and bind it up or something. Better to just pull it out and open it up. Should take a minute or two to do.Comment
Comment