messin around

[knownothingmags]

ill definently see what i can do.

[knownothingmags]

If this was made it would be nice to have the area around the lpr fully exposed for ease of tightening and have a 3 sided plate l_l that could be screwed on afterwords to enclose it.

like this?

before i go makin it pretty i wanted to have somthing basic setup.

this way i can make |_| to go around the grip to enclose it? and screw in.
would you want two or three screw down points on wach side?

[Flatliner333]

Yup that's what I was thinking with like 2 screws on each side. I would have the lpr screw down into the bottom side into the L shaped air channel. You could drill/tap straight up through the bottom for the lpr and horizontal from the bottom back side. You could choose were to put yor air fitting and block off the other one. By having the channel run horizontal on the bottom you could keep it away from the top mounting screw holes.

[knownothingmags]

Yup that's what I was thinking with like 2 screws on each side. I would have the lpr screw down into the bottom side into the L shaped air channel. You could drill/tap straight up through the bottom for the lpr and horizontal from the bottom back side. You could choose were to put yor air fitting and block off the other one. By having the channel run horizontal on the bottom you could keep it away from the top mounting screw holes.

oooh i was screwing the lpr up.
ill make one to screw down and see what feels better. virtually, since i cant machine yet.

[KurtPB]

Not sure if it's just not anyone's preference or what but kind of thinking in line with Luke's manifold and the emag battery. Why not make a foregrip to work with the manifold like a battery pack but just make it long enough to house the LPR's and anything along with it. I'd imagine it'd be like a shorty-reg or not too much longer than a standard HPR, look pretty clean and not have a ton of empty space below the LPR...?