Sear pin problems

[allies05]

Ok...I recently bought a MicroMag from someone on these boards, and he warned me of a slight problem it had...the sear pin falls out if the gun is slightly jostled around. An easy fix to this is putting a small object right over the pin and then taping the whole thing. I was wondering if there as any other more permanent ways of fixing this, maybe the pin isn't the right size?
Plz help, thanks!

[BlackVCG]

Micromag pins are special in there own way, so if it fits the gun it's probably the right pin. The hole in the mainbody is probably too loose. Take a small center punch and hit the aluminum on the mainbody right next to the pin so that it indents the aluminum and causes a bit of aluminum to "grab" onto the pin and hold it in place.

[allies05]

thx...i'll try this