Simple X-mag Question

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • neogp
    Registered User
    • Feb 2013
    • 15
    #1

    Simple X-mag Question

    Is the feedneck threaded into the stock block or pressed?

    I removed the set screws (one AM and one MM..)

    figuring if its threaded has a wee bit O'loctite. warmed her up with hot water...hammering.gif

    argh.gif

    no gots..


    Help?!
    Tags: None
    • splat15k
      The Beast from the East

      • Oct 2001
      • 1227
      #2
      It is pressed in for sure.
      My AO Feedback

        Comment

        • Dark Side
          RPG Fan Club President
          • Sep 2005
          • 1212
          #3
          To my knowledge, all Xmag breeches are pressed in.

            Comment

            • C_losjoker
              Puro Tico
              • May 2008
              • 1121
              #4
              What set screws, only automag that I can think of with set screws is the micromag?

                Comment

                • splat15k
                  The Beast from the East

                  • Oct 2001
                  • 1227
                  #5
                  Originally posted by C_losjoker View Post
                  What set screws, only automag that I can think of with set screws is the micromag?
                  The x-mag modules have two set screws that clamp down on the feedneck for extra insurance. They cannot be seen unless you remove the module and look just above the breach hole (one on each side).
                  My AO Feedback

                    Comment

                    Previous template Next
                    Working...