Emag electronics

[TimberlineShoot]

I'm recharging it at the moment but a week ago when we were testing it we were getting almost 18 out of it

[OPBN]

do a full charge on it. Leave it on for a good 10-15 hours and see what happens with air and a full battery.

[Justus]

If it's not shooting in E-mode now, you may have adjusted the trigger magnet too far back from the HES, so it can't pick up the magnetic field. Here's a good link on proper trigger adjustment: http://www.zakvetter.com/pages/paint...g_trigger.html

[SeeK]

The short version: You can easily test if the trigger magnet is too far back by powering up and putting your allen wrench between the trigger and the HES. If it goes off then you need to dial it in. But since it'll make it a larger magnet it'll make a larger magnetic field so you'll have to dial it in a little further than when you test fire. Or remove the wrench when you test fire to check the activation distance.

[TimberlineShoot]

OK I did get the electronics working but now my gun is out of tune.
Any of you guys have tips on doing that?
Thanks for all the help getting electronics working!

[athomas]

What kind of out of tune is it? What exactly is it not doing properly?

[TimberlineShoot]

To get it chonoed right

[OPBN]

To get it chonoed right

Insert an allen key in the velocity adjuster in the back and adjust it accordingly. Using a chrono helps.

[TimberlineShoot]

OK. Um one last stupid question is there a way to take the ball per second cap off?

[athomas]

OK. Um one last stupid question is there a way to take the ball per second cap off?

You have to upgrade to a newer version of the software. The best one is a non-AGD program called X-mod.

[TimberlineShoot]

OK thanks for the help