Automag RT not firing and bolt sticking

[billski]

I just got it back from AGD. The went through it and replaced everything. I ran oil through it, running a 950 psi shp tank. And this is the outcome. Click the link below.

http://www.youtube.com/watch?v=5ptqa_25AJE&feature=youtu.be

Any help would be much appreciated.

[Laku]

Make sure your field strip screw isn't too tight. In some cases that can cause similar behavior.

[athomas]

Just because they replaced the orings doesn't mean the level 10 is properly tuned. Remove the powertube shims and go to the next larger carrier size.

[OPBN]

Is that a Lukes Vert feed mod on that RT?

[billski]

Do you think that the level 10 is sticking? I am not sure what feed mod it is. I bought this marker used.

[athomas]

It sounds and acts like level 10 bolt stick.

[billski]

Its funny. I tightened the banjo bolt down, and what do you know, it herniated and got stuck. I took it apart put it back together with the 950psi tank on it did the same thing. So i put a standard hpa tank on there and it shoots fine.

[athomas]

That means the air path was clogged when using the SHP tank.

[billski]

What should I do to fix this bolt sticking? When I have it aired up it fires good. But then It stops firing when a drop a ball in it.

[athomas]

Have you checked the velocity? If the gun fires but not when a ball is in the breach, it is usually because the velocity setting is not high enough for the bolt spring you are using.

[billski]

I turned it up all the way and it fires good. Ill have to chrono at the range this weekend.