EMAG 3 & 6 burst????

[lovejtwo83]

I have the instruction manual but I still cant figure out how to get the burst modes to work, I just got the gun the other day and haven't figured it out yet. I can put a picture of the inside of the handle up tomorrow. So that you guys can see if I am missing anything or what ever.

[Kevmag]

Grip buttons

Push the top grip button until you see 1-shot. Then press the bottom button to switch to 3 or 6 shot. Pretty sure this is in the manual.

[lovejtwo83]

yea but that is not working and the instruction manual says something about a jumper and I dont know if mine is installed or not.

[BlackVCG]

If you take off the grip panel you should see three white plug connections on the board. If there isnt' a plug with a looped brown wire in the bottom plug in, you can't access burst modes. You can get that plug from AGD.

[Kevmag]

look at this...

http://www.automags.org/forums/showthread.php?s=&threadid=26292&highlight=jumper+emag

The jumper for burst mode is the one with the brown wire. It is supposed to be there by factory defaults. If it is not there, you're stuck w/ 1 shot only. I'm sure AGD will send you one.

Good luck.

[lovejtwo83]

alright thanks for the help guys... I now know that I am going to have to get a jumper because my Emag doesn't have one, I figured that was what I was going to need but I wasn't for sure because I had never seen what one looked like.

[LaW]

dO YOU really need it?? I mean most fields won't allow the use of it at all... oh well i guess it's fun to mess around with.

[cphilip]

My Emag came to me with the bottom button not working at all. At first I thought it was missing the jumper but turned out it was a defective board only for that button. I am remiss in not having sent it in to fix that but to tell you the truth I have never needed to change it. Its stuck in 16 bps 1 shot which is normal play but I do want to get that done just to demonstrate it to folks. Had a RA number for months now so I just need to find a time to do without the Emag for a few weeks and get it done I guess.

SO...if the jumper doesn't work and fix it then you may need a tune up. Does your lower button change anything else for you? Mine does nothing in all modes right now.

[Kevmag]

not really necessary...

No the burst mode isn't a must have, but it is a lot of fun to play around with... I'm sure the novelty will wear off as the cost of paint useage increases.