I am getting a center flags hyperframe, I have an intelliframe, but is there a way that I can directly wire the warp into the hyper frame???? There has to be a way, because on both, (intelliframe and hyper frame) you are closing a switch.
-
-
Up
Up -
Getting one
I am getting one as soon as Dennis from Center flag does another run of the polished frames, about 2 weeks. Need this information, if not I will have to figure it out and post the results.Comment
-
Ive been told it cant be done. I would really like to figure out a way to do it since i have broken my warpfeed sensor. I think somone should just make an after market control board that has an intellifeed port.AO #765
CCM Series 5
Prerelease Impulse
Hyperframed Warped Mag w/flatline tank
Feedback.
Good to know that somone of Tom's status seeks "relief" from a sport he helped create. A sport now ruled by a single patent.Comment
-
it has been done
a guy on our boards did it he used what looked like to be a small ide cable i think it is in the official automag pictures i will look and find it and let you know his name also.good traders- agdmagman2001, magdude25,Geoff Noble, than205, X-plosive, speedball4life, CoFFey[NiTrO], Snakebite78, zads27Comment
Comment