what is the roccomended input pressure for a micro emag?
-
-
Anywhere between 650 to 850.
The higher the input pressure the more reactive the trigger will be in hybrid and manual modes.
that page has a lot of info on what diffrent input pressures do in relation to consistancy.2003 SuperBowl Champions!, THE New England Patriots!
He was constantly reminded of how startlingly different a place the world was when viewed from a point only three feet to the left.
My Feedback -
in e-mode
Is anything over 650 a waste of air???Comment
-
no because the consistancy also changes with the input pressure. Its pretty hard to explain, but reading the above link should help.2003 SuperBowl Champions!, THE New England Patriots!
He was constantly reminded of how startlingly different a place the world was when viewed from a point only three feet to the left.
My FeedbackComment
-
You won't use more air if you raise the input pressure. 650 will use the same amount of air as 1500. The reg on the gun takes it down to about 450 regardless of what the tank is putting out, so you use the same amount of air nomatter what is comming out of the tank.
What I would do, is put the gun in manual, then ajust the tank so you like the level of reactivmess you are getting.
Comment
Comment