classic valve - how to lighten the trigger pull?

[BTAutoMag]

it has to do with porting the rt on off in a certain way to all ow air to flow past the pin without making it want to rt

[Laku]

you can even lighten it further by using a drill on certain parts... I wont go into that

I'm not about to do this, but I would like to hear the theory/technical explanation how it is done. :)

[BTAutoMag]

you can even lighten it further by using a drill on certain parts... I wont go into that

[Deviant]

This is actually pretty awesome information I did not know any of this, now im thinking about putting a r/t on off in a Level 7.

[BTAutoMag]

you can even keep the classic orings in the top of the on/off as they are the exact same

[BTAutoMag]

nope, pops right in

[captian pinky]

yes but will not allow you to rt. i also think you have to remove the bottom orings to make it fit but i forget.

[djinnform]

if you use a ult you will probably run into issues with short stroking. i prefer the rt on/off.

the RT ON\OFF works in a Classic Valve?

[BTAutoMag]

rukh is half right

captian pinky is correct

An RT on/off with really lighten the trigger pull and it'll breathe new light into your mag

A ULT will lighten it alot but you run the risk of starving your mag for air

Luke's sear mod will make your trigger pull heavier

dont use non AGD products in your valve. AGD spent money to develop things the actually work in your mag

[captian pinky]

if you use a ult you will probably run into issues with short stroking. i prefer the rt on/off.

[rukh013]

Put a RT on/off in it or ULT it lightens the trigger significantly

Lukes trigger/sear mod as well... highly underrated/under-advertised

Reactor on/off is not as good as the RT on/off

[djinnform]

Is there any way to lighten the trigger pull on a classic valve? Are they any options with the ON\OFF? What does that "Reactor" ON\OFF do?