10-32nd micro or macroline fittings?

[knownothingmags]

does anyone make 10-32nd microline or macroline fittings straight or elbowed?

I need a threading input to be smaller than 1/8 npt but be able to hold the same preasure.

let me know what you can find.

I cant find much. and the stuff I am finding I think is for lp air.

thankyou,
KNM.

[need4reebs]

wat PSI?

[need4reebs]

here are some…but I'm not sure wat psi you need?

http://www.ebay.com/itm/Legris-quick...item4611cf5181

[knownothingmags]

http://www.ebay.com/itm/Legris-quick...item4611cf5181

need enough for normal running of an automag. nothing crazy like 4500 PSI but it would be nice if they are rated high enoughthat I wouldn't have to worry about them.

[need4reebs]

wat out put pressure tank would you be using? 800? 1200?

[knownothingmags]

wat out put pressure tank would you be using? 800? 1200?

I would like to use 1200,

[need4reebs]

wat are you trying to run the air to/from that has 10-32 threads?

[need4reebs]

and wat have you found so far???

[knownothingmags]

wat are you trying to run the air to/from that has 10-32 threads?

trying to keep the wall thickness of the hole for the fitting as thick as possible without look gawdy.
its for the triplemag.

[knownothingmags]

and wat have you found so far???

looked at palmers persuit. and McMaster carr
all seem to be lp, no rating on them so I can only assume low preassure.

[need4reebs]

trying to keep the wall thickness of the hole for the fitting as thick as possible without look gawdy.
its for the triplemag.

CCM fitting…either way a fitting has to be used…tha part that will possibly look gawdy….like you say…will be the airlines to the tank or ASA?

[knownothingmags]

remote to the tank, and one or two lines to the marker.
i just am looking for the smaller threads so that i don't have to make a hunk of metal off the back of this thing to make a distribution block to the 3 valves, also keep it looking somewhat clean with the airlines.

i probably just repeated myself of ton there sorry.

[need4reebs]

haven't seen a fore grip for this thing yet…is there any plans for that? if not may make/have made a gas-thru that all three lines can attach to up front…then a line from the bottom of the fore grip to the ASA and then ASA to remote. hard line would be pretty clean.

[knownothingmags]

yeah forgrip will most likely be made.
with that idea of yours though, wont there be a lot of lines running around?

ill shoot you a pm of my idea, video if that ok. maybe two. explaining what im thinking.

[need4reebs]