Milling ion frame

[river031403]

Can anybody here mill an ion frame to fit up to automag rail?

[rukh013]

they flush fit without to much trouble, just make a new front frame screw hole...

(super_stanchy)

http://www.youtube.com/watch?feature=player_profilepage&v=SPbQzj9ejBA

OR...

(Robertsr)
you could hide a full automag inside an ion body/frame for an ultimate sleeper

http://www.mcarterbrown.com/forums/d...y-got-ion.html



or you could do what i did and drop a hacked up rail into a broken ion





don't have one of the two parts together but i'm sure you can line the cuts on the frame with the rail...

[river031403]

they flush fit without to much trouble, just make a new front frame screw hole...

(super_stanchy)

http://www.youtube.com/watch?feature=player_profilepage&v=SPbQzj9ejBA

OR...

(Robertsr)
you could hide a full automag inside an ion body/frame for an ultimate sleeper

http://www.mcarterbrown.com/forums/d...y-got-ion.html



or you could do what i did and drop a hacked up rail into a broken ion





don't have one of the two parts together but i'm sure you can line the cuts on the frame with the rail...

THANK's keep the ideas coming
I'm familiar with stanchy he's just super busy with stuff so I may do it myself just wondering if there was a how to guide? But I'm sure I could just match up rail holes mark it and go from there.This is a mock up of my project phase one I still need some parts

[punisher068]

Are you thinking pnueMag for this project?Seems pretty doable.If you can find an aftermarket Ion frame for cheap they may be better,most have alot more space inside,the NDZ Scorpion frames a huge inside compared to stock ones.
If you need any measurements of anything PM me,I've got a ton of Ion stuff

[river031403]

Are you thinking pnueMag for this project?Seems pretty doable.If you can find an aftermarket Ion frame for cheap they may be better,most have alot more space inside,the NDZ Scorpion frames a huge inside compared to stock ones.
If you need any measurements of anything PM me,I've got a ton of Ion stuff

My intent exactly was to do a pneumag down the road pm inbound

[river031403]

This is the frame I plan on putting on my mag

[punisher068]

PM replied,sorry no Epif frames
Any reason the mech 3way on a pnueMag can't be replaced by the Ion solenoid 3way?

[river031403]

Getting closer waiting on rail to get back from luke...

[magman313]

you should mount the sear in the frame and skip the rail.

[river031403]

you should mount the sear in the frame and skip the rail.

I was looking at that possibly but I have to make sure it will work geometry of on off pin length trigger sear etc

[river031403]

Ok so qloader or bt rip clip to feed this need opinions

[river031403]

It's coming together nicely I think?

[river031403]

A little update
1.custom rail to match length of epiphany frame at the front
2.moded frame to fit
3. Shortened sear pin
Put air to it!!!!

http://youtu.be/vRtiYFAMjpU

[knownothingmags]

is it comfy?

[river031403]

is it comfy?

Berry comfy!
Next is either rt or ult on/off to lighten trigger pull a bit
Or I may just purchase an Xvalve with ult and level 10 from tuna