AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026.
Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Didn't realized How hard it will be to get the ball detent back in my emag, Anyone have any tips on getting it installed? The one located on the trigger select. I made a attempt with the safety pin and the ball went flying lol
use a lube to hold it in place, and then work the detent. that way, it will not hurt it and will stay in place till you get everything where you want it.
Comment