Emag Questions

[PsychoJester]

Had a few things going on so it was a little harder to troubleshoot. The trigger needed to be adjusted. The guy I bought it from had the set screw inside on the selector switch screwed all of the way in so there was not trigger movement at all. Also the battery was shot, It would boot up the board but maybe not enough juice to actuate anything. Also needed to set the magnet in the trigger to the way I like it. Plus a lot of just me not knowing the marker made it a little difficult to work through things. I still don't know what all of the things on the board mean??
New battery from Batteries Plus, got a 750 amp hour because that's what he had in stock about $70.00 with tax and he soldered the contact end on it also
adjusted trigger and trigger magnet and it worked fine
I'm running a Ninja SHP at 1100 output
AGD 3.2
What do these stand for
TS= total shots - but how do I set it back to 0
SPS=Shots per second - is this say set at 8 means no matter how fast I pull trigger it will only allow 8 per second?
ACE = ???? something to do with an eye??
SHBF= ????
Trigger on off = I know this one and it helped when setting the trigger because I didn't need air hooked up to do it

[Cyco-Dude]

Also the battery was shot, It would boot up the board but maybe not enough juice to actuate anything.

did you take a multimeter to it? also, the solenoid pulls the plunger down. you should be able to pivot the sear up / pull the plunger out a bit, pull the trigger while in "e" or "hybrid" mode, and it should snap down.

AGD 3.2
What do these stand for
TS= total shots - but how do I set it back to 0
SPS=Shots per second - is this say set at 8 means no matter how fast I pull trigger it will only allow 8 per second?
ACE = ???? something to do with an eye??
SHBF= ????
Trigger on off = I know this one and it helped when setting the trigger because I didn't need air hooked up to do it

here is the manual, it will tell you want everything is / does. total shots, i don't think you can reset. you are correct about sps and ace (anti-chop eye), but ace was only for the x-mag. no idea about the last one; could be the burst mode setting.

[PsychoJester]

Yeah I've looked through that manual and that must be for an older version board. Because mine doesn't have any of those modes, timer etc.

[athomas]

That is one of the last versions of actual factory released AGD firmware. There was 4.0 I think, but I don't know if it was actually a factory release.

The SHBF is a shot buffer setting so that the board can register a trigger pull before the end of the complete shot cycle. On the old firmware, if you set the rate of fire to 10, it translated into 100ms per shot. That means the board wouldn't register a shot if you pulled the trigger before the 100ms was up. The newer boards would register the trigger pull and hold the activation until the cycle time expired and then fire the gun again for that registered trigger pull.

I can't remember if this version has the full auto issues. You'll find out soon enough. If it does, you will need to properly orient the polarity of the solenoid wires to help with that.