cocker wont power up

[mogli]

tinkering with a super stock autococker i got in a group buy to make sure it works before i sell it. I placed a new 9v battery and it and pressed the button on the grip but nothing happened. I was able to cycle the gun using the button on the worrblade. Any ideas to track the power failure,

[athomas]

If you have a volt meter, test the voltage at the board where the battery leads are connected. That way you will know that the battery connection is actually good. Also, check the battery. Sometimes you just get a bad battery.

[DarkApollo]

The button pads on those fail. I can almost guarantee that is the problem.

[mogli]

thanks I'll check that tonight, battery is new and good, powers up two other markers just fine.

[DarkApollo]

I dont remember which wired jump to which (I think they might be labeled) but you can test to see if it turns on by jumping the leads on the connector.