warp feed problems

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • vintage
    Registered User

    • Aug 2013
    • 1787

    #1

    warp feed problems

    having trouble getting one timed to my e mag, it won't pick up the recoil most of the time in mech mode. in e or hybrid mode it works fine on 9v but in 12 it runs all the time.
  • Cyco-Dude

    #2
    is the warp feed plugged into the emag board?

    Comment

    • OneSelfLost
      Frontline with tha mag out

      • Apr 2010
      • 835

      #3
      Have you tried to take the back plate off and turn the sensitivity down until it stops spinning?

      Comment

      • vintage
        Registered User

        • Aug 2013
        • 1787

        #4
        Originally posted by Cyco-Dude View Post
        is the warp feed plugged into the emag board?
        yes

        Comment

        • vintage
          Registered User

          • Aug 2013
          • 1787

          #5
          Originally posted by OneSelfLost View Post
          Have you tried to take the back plate off and turn the sensitivity down until it stops spinning?
          yes

          Comment

          • Tunaman
            Specialized AGD Tech

            • Dec 2000
            • 8643

            #6
            The 12/18 volt mod uses 100 uf capacitors. Check to see if they are installed on both sides of the regulator.
            Email me for low prices on ALL AGD Products and more. [email protected]
            Tunamart

            Comment

            Working...