Warp concerns

[lloyd_kinky]

My warp is running off of one 9 volt and is on vibration activation(not intellifed). It feeds when i fire and everything, but it doesn't slip by and do the 1/4 spin thing. It just stalls. Should I loosen the 2 bolts that hold the drive wheel and slip disks together? Do my batteries suck? I have gone through several fresh ones trying to get it to slip after feeding.

Also, could I used more voltage with out worrying about frying the board? Would 2 9's regulated to 12V work> What about the 10.8V NiMH battery I read about somewhere else on the site.

Any insight would probably help. Thanks

[virus]

what type of paint are you using

also how many jumpers and what position are they in on the warp

PTP make a 12v mod for the warp or if you know what you are doing you could make your own....

[a_malfunction]

Well, sometimes you have to lube the discs. I use either a busted ball or some gun oil. It works great.

[Potatoboy]

When I was using cheap batteries I had the same problem. It's really annoying, but don't skimp on the batteries, use a good high quality alkaline battery, or get the Plainveiw 10.8v Nimh.