Clamping feed neck for classic automag neck?

[ideinit]

Hello AO,

I am wondering if a Geo feed neck (pictured) will fit over the my classic body's feed neck? (Vertically modded, but the diameter hasn't changed)

Eclipse_GEO_Feedneck_black.JPG


1508998_10102764472057664_291488736899820227_n.jpg

If not, are there any recommendation for attaching hopper to this body? I have been using the plastic vertical feed neck but those make the hopper too tall.


Thanks for the great support, AO!

[Walker]

Try one of these:

Lapco Clamping Feed Neck


Walker

[ideinit]

Try one of these:

Lapco Clamping Feed Neck


Walker

Thanks for the rec!

[Cyco-Dude]

if the lapco feednecks are out of stock, you can also get one from palmers.

[ideinit]

if the lapco feednecks are out of stock, you can also get one from palmers.

Awesome, that gives me an alternative to work with. Thanks!

[BigEvil]

If anything it will be a little too big, not too tight. Add a few orings or some tape to take up the slack if it's loose.

[OPBN]

Those Palmers ones look nice. Might have to get rid of my Redz one for one of those.

[athomas]

Hello AO,

I am wondering if a Geo feed neck (pictured) will fit over the my classic body's feed neck? (Vertically modded, but the diameter hasn't changed)

[ATTACH=CONFIG]91358[/ATTACH]

All I can say is "Probably". Most straight, non-threaded feednecks are 7/8", which is the same as the automag.

[Menace_AO]

One of the Empire versions will fit. Think it might be the Axe/Mini version that also contains the threaded body adapter, which is ~same OD as the feed tube. Don't quote me on it being this model. I think it is, but cannot be certain. But either way, I saw it go straight out of the box and right onto the mag feedneck tubing. Fit snug, was easily tightened, and looked pretty decent.

I also like that it's a lever lock. If only LAPCO made one of those . . . .