x valve slow recharge rate

[magman313]

My xvalve is recharging very slowly, i can actually hear it recharging. All the o rings are in good condition, would it be my spring pack i would want to look at? The valve was recently rebuilt too. Im running a shp reg set at 1100 psi.

[Cyco-Dude]

hmm...what exactly is it doing? is the sear / bolt / level 10 binding at all? have you tried a different tank?

[kfletch]

Check your Reg. valve pin assembly.

[athomas]

Is the trigger resetting immediately following a shot? If not, then your problem is bolt stick and is most likely caused by your level 10 bolt being out of tune. It the trigger is resetting quickly, but you still can't shoot because the front chamber is not charging, then your issue is either an on-off issue caused by a trigger rod that is out of adjustment, a ULT (if one is installed) that is out of adjustment, or a dirty valve issue.