Broken LED display?
Hello everyone,
Awhile back, I had my X-Mag apart going through some maintenance and tuning. Put everything back together, flipped the switch, ...and nothing. No hint of life from the display. Nothing was bent or installed incorrectly. Pulling the trigger in E and Hybrid modes cycled the solenoid.
After a year or so, I take the mag out yesterday because I'm trying to start playing again but I'm still having the same issues with the LED display. It had the old 3.0 software... or something along those lines. Semi is all it would do (even with the jumper cable). The board appears to work, but the display refuses. I've looked around to see if anyone has had the same issue with no success.
The mag cycles fine in all modes. I really can't afford a new $200 board right now. Any help?
I have adjusted the lower magnet location further away from the board to see if it was a boot issue. No luck.
Awhile back, I had my X-Mag apart going through some maintenance and tuning. Put everything back together, flipped the switch, ...and nothing. No hint of life from the display. Nothing was bent or installed incorrectly. Pulling the trigger in E and Hybrid modes cycled the solenoid.
After a year or so, I take the mag out yesterday because I'm trying to start playing again but I'm still having the same issues with the LED display. It had the old 3.0 software... or something along those lines. Semi is all it would do (even with the jumper cable). The board appears to work, but the display refuses. I've looked around to see if anyone has had the same issue with no success.
The mag cycles fine in all modes. I really can't afford a new $200 board right now. Any help?
I have adjusted the lower magnet location further away from the board to see if it was a boot issue. No luck.
Comment