Needing a Mag-Master

[jarhead86]

In anticipation of the Evo body I'm in need of someone to assist me with my build. I know about nothing when it comes to e mags, ep conversion or why have you. So if anybody out there can help me out, and would like to make a little $$$$ please let me know. Thanks

[luke]

My lowers are pretty much turn key, the only thing I would question is running the low pressure line through the body. There would be a solution I just know what XMT is machining in the bottom of these bodies.

Several choices of LPR-FGs available.
Two frame designs, double of single trigger types
4 trigger designs for the Double.
T-Rex for the pneumatics



The kit would be complete except for the grip frame screws, AGD safety assembly and rail bushing.

[knownothingmags]

I can help or there are others.

[luke]

I can help or there are others.

Looks to me like he's asking, what is your input? lol :)

[knownothingmags]

Looks to me like he's asking, what is your input? lol :)

oh, yeah lol
so...
there are many ways to go about pneumatics or EP mags now.(as in components)
depends on what you decide.
most of us are here to help.

[jarhead86]

Looking to use a dye UL frame, and I will be getting the forgrip that XMT is making post body run. How complicated is it to use that frame and is there a particular year that would be easier to use?

[luke]

I dont believe the DYE frame is a candidate for the T-Rex so you would have to go a different route for pneumatics.

[jarhead86]

Stupid question #1
What parts are required of me to do a ego/ electro conversion but with the dye frames? And is that the same thing as the ep?

[jarhead86]

So if I wanted to make it like the ego/ electric frame but use the dye, what parts do I need to make it work? And is that the same as the ep mods?

[BIG BOB]

Do you already have the dye ul frame? If not they are a little tricky to track down as I believe the best candidate is the dm5 ul frame.

[luke]

Wasn't there problems with the DYE frames?

[jarhead86]

I was going to buy a whole gun, go the donor route. I think it would be cheaper than tracking down the barrel, frame, Asa, etc. Then sell off parts I don't need. I've seen a couple 7's out there, a couple 4's as well. I'll have to keep an eye out for a dm5

[BIG BOB]

The dm5 ul frames were the only ones that had a flat top. All the other models had a weird curve in them that matched up the Vasa.

[Laku]

Check this out. It's pneu, but gives an idea about the ram mounting and how little room there is in the UL frame.

http://www.mcarterbrown.com/forums/a...d-pneumag.html


I've also seen pictures on Facebook of few home brew cheater pneu systems in UL frame done by need4reebs

[renie]

dye frames can be done some of the pmr frames had flat bottoms too