I live in howell nj. looking for a good tech that could help with my x valve setup. Gun works fine with the classic minimag valve. Just got an xvalve and am having problems after problems. mostly air leaking down barrel when trigger is held in. I know its the on/off valve. or thought that. i have changed every o-ring and cant get it to stop. i have tried two diffrent on/offs still same problem. Have never had so many problems with a valve. I just got the thing new from agd. It hasnt worked right since i got it and am pulling my hair out trying to figure the thing out.
-
-
Have you checked the o-rings inside the L10 carrier? Or are you just too frustrated at this point and want someone else to fix it for you. -
Send it to Tunaman
Comment
-
lvl ten works fine.. it was on/off. i ordered a new set of o-rings. I figured out the on/off wont push all the way down into valve i think one of the orings is wrong on it. since i got it i always had to use a small screw driver to push up on on/off so the valve would slide in. not the pin the whole on/off body.Comment
-
Some of the best techs are in your area. Tunaman is in NJ & BigEvil is on Staten Island.Originally posted by dano_____Comment
-
Some people would put ULT or Lvl10 shims under the screw-on top on the RT, to get more trigger bounce. If that is the case, you would want to measure the on/off pin length while you are in there to make sure it is not too long before or after you remove shims.
Squashing the on/off in there can increase the tension on the top o-rings, which would work against the extra trigger bounce you hope to get by pushing the top up.Comment
Comment