Classic Valve On/Off brass top hat Dimensions

[renie]

has anyone got the dimensions of the brass top hat in the on/off for a Classic valve
I haven't got one to hand to measure and a friend has lost his, so I thought it would be easier just to knock him up one at work.

Any input appreciated

Cheers
Ren

[Sandman]

On/Off Top <----link to product

They cost $7.00 for new one....probably 100's laying around used for less.
I guarantee you will spend at least $200 in time making one.

If it was A $100 part.....maybe...it might be worth it...

[renie]

there cheap as chips I know, but being in the UK has its down points when it comes to mag stuff (:
it would take me 5 mins on my collet lathe to make one tbh perks of being an engineer
only want to get a classic valve back up and running for a friend

[Spider-TW]

I'll try to remember to dig one out.

[captian pinky]

Ill take some measurements when i get home today.

[renie]

Thank you guys appreciate it

[Spider-TW]

I had remembered on the way home, but that thought was destroyed when I got there. We have a wedding going on this weekend, chaos reigns. I have hope still.

[Spider-TW]

Thickness = 0.1865"
Diameter = 0.3715"
ID - 0.1475"
ports (4) = 0.0875"
small diameter/waist = 0.271"
waist height = ~ 0.115" it looks half-circular between the inner and outer diameters, so that would be about right.

[renie]

Thank you