X Valve Trigger problem.

[nak81783]

tucson,

Where in the trigger stroke does it initially fire -- start, middle, end?

[tucson.az.jbreen]

I see your point , and it does sound backwards.

With the stock .750 pin, there is no semi auto fire. If I squeeze the trigger all the way down, and try to hold it, the marker would continue to cycle.

[Spider-TW]

Also with the longer stock pin, I was unable to get my valve to do single shots, it bounces and shoots full auto no matter how you work the trigger.

Is that what you meant to say? It sounds backwards.

[tucson.az.jbreen]

(more of an additional question then an answer, but...)

Sounds allot like my problems. I believe the source of my problem was the length of the on/off pin. I have yet to do field testing, but I believe replacing the pin with a shorter one fixed the problem

Also with the longer stock pin, I was unable to get my valve to do single shots, it bounces and shoots full auto no matter how you work the trigger.

Does this sound like you're set up at all?

Thanks, Jim

[nak81783]

Sounds like bolt stick. Tune the Level 10 per athomas' guide in the Level 10 sticky.

http://www.automags.org/forums/showthread.php?43538-**-Official-Level-10-Problems-Thread-**&p=2868950#post2868950

[Fancyfingers]

Hey guys, I come to you seeking advise from the wise. I know a little bit about mags and such but this one is breaking my stones till no end.
I have X valved ULE mag with an inteliframe. I got her to RT nicely, but every now and again the bolt just goes dead. The trigger pin has pressure to push the trigger forward, but pulling it doesn't fire the marker.
I have to de-gas and re-gas the marker and she shoots until it happens again.
Any ideas or help would be appreciated.
Thank you oh great Mag Gurus
(If this is in the wrong section I apologize and will gladly move promptly)