HELP: Question about intellifeed wire and turbo board

[Wildman]

I see in the picture on the instruction for hook up, That the black wire goes under battery terminal oppisite of the switch. Now, I've got a 12v with turbo board and it has the plugs for connecting the batteries. Also, on the instructions for hook up on the switch, there are no black wires in those pic. but the other end of the cord, they say there is a black wire. Mine is the same on both ends. 1 bare wire, 1 white coated wire.
So another question is; Is the black suppose to be #1 or #3 on the switch?

I'll check back in a little bit. Hope I can get help.
Yhx,
A.J.

[kutter]

Wildman I thought that the instructions for the Turbo board specifically said not to wire it to a trigger as it would cause problems and actually make it slow down.

But I could be wrong, it has been a while since I was at their website.

[Wildman]

I never checked their web site, just used the papaer that came with the frame. I'll have to look that up. If I can't do it that way, I guess I'll buy an x-board. It should work with the x-board won't it?
Thx

[kutter]

Actually I think both of them say to not connect them to a trigger, it has something to do with the software and the eye sensor and how fast it responds. This is right from the Warped Sports website.

"The Intellifeed interface for various guns provides a method to spin the hopper motor every time the trigger is pulled. Although this does help increase the feed rate compared to a stock Revolution, the Intellifeed does not "know" what is going on inside of the hopper and therefore can not feed the balls at the fastest possible rate. The TurboRev board takes the place of your stock board and Intellifeed completely! The TurboRev board can outperform any type of external logic because it has the advantage of being connected directly to the photo sensor and agitator motor. The Intellifeed would slow down the TurboRev, so they are not compatible!"

I suspect that the X-Board is the same way.