What's the top width of an automag frame? We have a mill at work, and some scrap aluminum, and was contemplating playing around with machining a trigger frame.
Sent from my ASUS_X008DC using Tapatalk
Sent from my ASUS_X008DC using Tapatalk
-
-
Get a set of calipers and take your frame and measure it up. You will need to get some measurements like the rear frame hole, sear placement and the front screw exact. After that, you can do whatever you like. -
Start with a 3/4" piece of stock, face both sides at -0.015" and you're off to the races.Originally posted by brokeass_baller View PostComment
-
Thank you! My mag currently doesn't have a frame, so I have nothing to take measurements of. I think I can eyeball the sear slot. I just wanted to make sure I had the right width for it.Originally posted by luke View Post
Sent from my ASUS_X008DC using TapatalkComment
Comment