resurrect xvaled mag help

[dannypwr]

I bought all the part to create a UL xvalve mag . right now with an HP tank the trigger pressurizes and i can hear it click and feel pressure behind the trigger. the prob it wont shoot. need some advice before i go crazy. i did up the velocity/pressure withe the back adjuster all in and all out. so, do you guys think i need to bring out the trigger rod? is my on/off poopie?

thanks

[luke]

Is there a gap between the trigger rod and the back of the trigger when it's aired up? If not adjust the trigger rod.

[Nobody]

Make sure you are using a HP air tank. Anything less than 600psi, it will pressurize but not fire.

[luke]

Also, if you have trigger stops and they're not adjusted properly it can act like an improperly adjusted trigger rod. If you do have them back both completely out and try again.

[athomas]

I bought all the part to create a UL xvalve mag . right now with an HP tank the trigger pressurizes and i can hear it click and feel pressure behind the trigger. the prob it wont shoot. need some advice before i go crazy. i did up the velocity/pressure withe the back adjuster all in and all out. so, do you guys think i need to bring out the trigger rod? is my on/off poopie?

thanks

Is the level 10 properly tuned? A carrier that is too tight or a bolt spring that is too stiff won't allow the bolt to release when you pull the trigger.