Problem with plastic nubbins and orings???
Okay when i put my orings over my plastic nubbin the orings stick up really far. Then when i go to put it into my gun the orings pop off or break. When they dont do that the barrel goes in really hard. Any help would be appreciated. Thanks.
-
-
put some oil on the orings, that's just how they are
I thinkt hat the backs of the nubbins are made too thin also... i've had a couple breakTaking a long needed leave of the sport to finish school and tour the country
b2k3w/pds, vaporized, vapor valve, aka sidewinder, chaos chip, palmer rock lpr, CP barrels, 68/45 hyperflow
B2k3 w/pds and bunch of upgrades for sale -
The new ones are thinner so the o-rings don't stick up as far. They have the mold fixed and the new ones are working great. The online store has them.Comment
-
thanks...
thanks for the info i think ill order some of the new ones today.
Comment
-
Just take an exacto knife or boxcutter and carefully trim out a bit of the nubbin where the o-ring rests on it.
Comment
-
k...
Ill try that if i have to but i hope the new ones will work well anyways.
Comment
-
Order the new ones, and for now just file out a little groove in the ones you have.
Comment
Comment