RT Pro Level 7 parts and O-rings

[dahoeb]

I just bought a beautiful RT Pro thats Level 7. I don't really have a desire to upgrade to an Xvalve or Level 10 (at least at this time), and with a Rotor, chopping shouldn't be too big of an issue. My question is this....

I've never owned a Level 7 RTP valve, but taking it apart, I've noticed some difference. Around the On/Off pin...there is what appears to be a white o-ring (teflon?) instead of the large and small o-ring around the pin. Can/Should I put the Large/Small o-rings in there and rip out that white one? The gun tests fires fine as is.

Finally...

I'm looking to put a fresh set of o-rings in there....will the X-valve rebuild kit have what I need for a Level 7 powertube o-ring replacement? Not sure how different it is from level10.

Thanks

[Tunaman]

Get an RT parts kit. The only parts you wont use are the 3 RT classic banjo bolt orings. You also get the mainspring in this kit. I have them if you need one. Email me. [email protected] The white teflon oring is for the Automag and should not be in there.

[dahoeb]

Thank you very much for the help, Tuna....email inbound!

[athomas]

If you look into the on-off area, you will notice an indentation bored at the bottom of the hole. A single urethane oring sits in there. You cannot use the 2 oring setup in this valve if this is the case. It only uses the one smaller whitish urethane oring for the on-off top oring.