Macroline and Fittings on Nummech Frame

[jbtamu1011]

Also, I felt sick to my stomach when I made that little knick.

[Tunaman]

Butchers!

[TheRealKaz]

Yeah, the ccm fittings won't work with that rail due to the wing. It required a pretty flat rail in my experience. It works with the ule rail and Luke's extended rail.

I'm sure more rails work but I only have the two I tested.

[jbtamu1011]

Hey guys, so I have some issues again with the fittings. I have an Armada rail now so no big wide wings to worry about. My question is more on the CCM fittings. I have their regular post in the valve and the extended post for AGD in the frame. Is that correct? I'm getting a big leak around the fitting on the frame. Please advise.

[Gundam V]

Where exactly is the leak coming from? The threading in the frame from the top of the ccm fitting? Is the oring in that fitting free from damage?

Sent from my SM-G970U using Tapatalk

[jbtamu1011]

Where exactly is the leak coming from? The threading in the frame from the top of the ccm fitting? Is the oring in that fitting free from damage?

Sent from my SM-G970U using Tapatalk

Not too sure where the leak is coming from. I'll try resealing the fitting in the frame. The fittings are brand new with new orings. I'll double check the oring in case I damaged it or pinched it somehow.

[jbtamu1011]

Hey guys, so I have some issues again with the fittings. I have an Armada rail now so no big wide wings to worry about. My question is more on the CCM fittings. I have their regular post in the valve and the extended post for AGD in the frame. Is that correct? I'm getting a big leak around the fitting on the frame. Please advise.

So, do I have the correct length fittings from CCM on the valve and trigger frame? Short fitting post on valve and longer fitting post on frame.

[Gundam V]

Yes

Sent from my SM-G970U using Tapatalk

[going_home]

Is that an idiot mark I see on that valve?

Its a Tunavalve for crying out loud.

Why ?

[jbtamu1011]

Its a Tunavalve for crying out loud.

Why ?

I already felt bad enough when I did it. Got over it. Now you brought up those feelings again

HAHA

[jbtamu1011]

Hey guys, still having a bit of trouble with getting my fittings to not leak. If I tighten down the fitting on the frame, it sits below the fitting on the valve. That's with the extended AGD ccm fitting on the frame. How much do i tighten the fittings? Also, should i use thread sealer instead of tape? Is this a good sealer for all paintball use?