I upgraded my mag to a ULE rail. It is sweet. But my old school smart parts vertical grip cant immediately mount up to the new rail. Where the vertical grip would mount on the rail, the center hole is not drilled yet, and there are 2 other holes on either side of the "center". Are there specific vertical grips to use? Should I drill the center hole? I'm not looking for ASA, only a grip.
- AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026. Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Comment