Tuning a RT Classic

[whpraveman]

Smear RT Classic, level 10, inteliframe double trigger. I just replaced all the o rings in the gun with genuine AGD parts kit.

Issues.
Leak down barrel-using smallest carrier size-When I hold the trigger down the leak stops.


What spring should I use? I have red and gold.


The trigger rod on the sear needs loctite. What is the proper amount of threads showing before I loctite it?


What "super glue" should I use to glue the foamie back on? Super glue never works that good btw.


Thank you!

[Gundam V]

For the carrier, try a different oring in the carrier. Since orings can vary so much try different oring and test on the level 10 bolt stem there should be some friction and test again. The gold spring is the best all round to use. Trigger rod length should be at 1.980 if I recall correctly. Lastly for the foamie adhesive I was recommended to use Bob Smith Industries Maxi-Cure adhesive, so far its holding up really good.

Sent from my SM-G970U using Tapatalk

[whpraveman]

Thank you. I will give that a try.