Intellifeed problem, Revy goes nuts when I plug the jacks together!

[MikeCouves]

Okay, I got my Revy and Intellifrane all successfully connected, but when I plug the jacks, this is exactly what happens.

The speed of the paddles speeds up.

The Revy will not stop spinning. Even when I put my finger in the eye the revy doesn't stop.

I don't know what to do, me and my dad have been stumped by a little bit of wires and metal .

Help me out guys I want it to work!

[a_malfunction]

Sounds like you have the switch mounted too close to the trigger rod. I set up the intellifeed on my brother's mag and it did that when I first set it up. Just loosen the screws holding the switch to the frame and push it back a little bit. Then re-tighten them and test it. Repeat if necessary.

[MikeCouves]

Okay let me try that out. I'll be back in a minute, stick around!

[a_malfunction]

Will do!

[MikeCouves]

Got it figured out...

Well that wasn't the problem. The problem was in the female end of the jack. The connections were always together causing it to always spin, my dad was using a little meter thing to see where connections were and stuff, and I didn't know what he was doing, but a little tape and bending got it all to work!

Woohoo I got Intellifeed. Sweeeeet.

Thanks alot anyways!