I am getting a Flatline...the Drop Forward...

[MikeCouves]

Hey I am getting a Flatline 68. I know that the drop forward is pretty short and I like to be as low profile as possible. So I was wondering if I should just get a regular drop forward like this(Image Below)



That should work...I think. Well let me know please.

[Load SM5]

It did'nt show up. I know you can mount them on a Kapp DZ2.

[MikeCouves]

Damn, stupid image. I'll try again. Well Kapp DZ 2 because they are too expensive. I just want a cheap one like this(Image Below).



That one should work. It's a Shocktech. LMK.

[MikeCouves]

Ahh, that's a big pic. Sorry bout that.

[CDN_Drew]

Mike

If you want to run it on that drop forward you'll have to get a custom products flatline adaptor. What it does is mounts in place of the flatline drop giving you a rail type mounting system. This will allow you to use most drops that are on the market right now, as long as they have the rail on them.

[MikeCouves]

Are you sure? Because I am using the old drop forward and a new one. I am double drop forwarding it.

[pharcyde]

you can double drop it with the shocktech and stock.

[MikeCouves]

Deadly, I will do it then!!

[Dubstar112]

on my flatline, i measued the dia. the slimmer part of the reg measured an inch and an eighth, i believe this would work on a kap dropzone with minimal effort.. and if its to small you can drill the dropzone out.

[MikeCouves]

Right on I am going to get like a cheap drop forward and double it.

[MikeCouves]

...

[Dubstar112]

I emailed cam metalworks about that flatline drop and he quoted me 38$ for that longer df shown above

https://www.cammetalworks.com

[Dubstar112]

theres another one

[MikeCouves]

Cool

That looks pretty nice I must say. What kind of DF is it?

[Dubstar112]

Im not sure what its called but Craig from CAM Metal works makes them .. go to the link i mentioned above look around on the site youll see more of his creations