Does AGD make a longer on/off pin for RT valve?

[thecavemankevin]

I have a RT valve and tried hooking it up to my hyper frame and the pin isn't quite long enough to reset the servo each fire. So i tried a slightly long Centerflag version and the diameter isn't quite wide enough to fill in the AGD on/off assy.

Any advice?

[PyRo]

Well, I don't think it makes much of a differance with electo frames what your on-off leangth is. But yes, they do.

[Butterfingers]

Thats actually not the problem.

The on/off pin of any length actally can extend further than the sear allows. The the sear stops the pin from further movement, not the pin itself.

The centerflag on/off pin is slightly smaller in diameter making for a lighter pull and less stress on the solnoids.

You have to twist open the two halves of the on/off assy and replace the stock o ring with the smaller centerflag o-ring. Yes the brass peice twists apart.