Mag Problems.........................

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Mag89
    Senior Member
    • Aug 2001
    • 455

    #1

    Mag Problems.........................

    I have a automag 68 and when i go into a rapid fire the gun works fine the after a second in rapid fire the gun locks up in a way.very
    little air comes out the end of the barrel and the paintballs just roll out of the barrel i am running nitro. This happens somtimes with drop foward and when it does i de-gas it then re-gas the gun and it works fine until it happens again.But when i run remote it never happens and i dont really like remote.
    AIM:Mag2589
  • Mag89
    Senior Member
    • Aug 2001
    • 455

    #2
    I think i fixed it I will report back if there are any problems with the gun.
    AIM:Mag2589

    Comment

    • slapshot
      Registered User
      • Jun 2001
      • 137

      #3
      hey what was the problem, that happens to me sometimes, and i just never bothered to figure it out.



      let me know, thanks

      Comment

      • Mag89
        Senior Member
        • Aug 2001
        • 455

        #4
        well first i ordered a new trigger rod, second, there was an obstruction in the air hose but when i tried to get it out it never came out but i might not have seen it. i am not sure if this will fix the gun but it will probably will.
        AIM:Mag2589

        Comment

        • Chef123161
          Registered User
          • Jan 2001
          • 374

          #5
          Hmmm....

          It sounds like the output pressure of your HPA Tank isnt high enough. What kind of tank is it? Preset or adjustable? The reason it works fine with a remote is because the remote hose allows more air to be between the tank and the gun.

          Comment

          • mac2k4
            Ca$h money
            • Jun 2001
            • 362

            #6
            ya were gettin shoot down, common with'emm all but shouldn't happen after 2nd shot.
            make sure ya got about 800psi runnin into vavle, and ya shouldn't have as much of a problem.

            Comment

            • Mag89
              Senior Member
              • Aug 2001
              • 455

              #7
              It is still doing it......it is a 48cu 3000psi tank. when i got it it was working fine then this problem started happening. But my cousin has the same drop foward setup and tank and he has no problems with it.
              AIM:Mag2589

              Comment

              • Chef123161
                Registered User
                • Jan 2001
                • 374

                #8
                Ok...

                I guess it is a preset. It sounds like the output pressure of the regulator is too low to operate your gun during rapid fire. I had a similiar experience with a preset tank. My friend and I both got the same tank and mine wouldnt even allow the gun to cycle while his worked flawlessly. Sent it in and found out the factory preset was way too low. So this is most likely the case.

                Comment

                • Mag89
                  Senior Member
                  • Aug 2001
                  • 455

                  #9
                  I will try and play with my cousins nitro tank and see what happens............
                  AIM:Mag2589

                  Comment

                  Working...