Timmyripper/warp problems. Assistance please?

[Plasma69]

Hi

My Setup. Ripper timmy with select fire board, and warpfeed wired to the gun itself like Petty paintball. and paint used is PMI premium bore .689 roughly.

Well. yesterday, i got my warpfeed all ready to go for the tourney, and after a game, i noticed that it wouldn't feed fast enough. i can't shoot long strings. from what i see in the proteam adapter port hole (unno u can see the balls go through). i had a 1/2 inch gap about between the balls. hard to explain i'll try and get pix. its like the warp wouldn't turn more. like it doesn't turn enough to stack the balls close to each other. Is there a way i can adjust that?

2nd problem was some of the balls got the warpfeed stuck. Like, some balls were toooo chubby or something and it jammed the warp completely. Tried to push the white button to move the warp, but it wouldn't turn over. Is there a way i can adjust that?

I hope. i was clear in stating my problems. if someone could offer me some assistance that would be great.

PS. We took home 1st place. muhahahaha..........

[hitech]

Re: Timmyripper/warp problems. Assistance please?

Originally posted by Plasma69
PS. We took home 1st place. muhahahaha..........

Congratulations!

As for your warp problems. The paint you were using has the "new" advantage shell. It is a "dry" shell and provides more friction than the "older" style shell. One easy fix is to "oil" the disks. Break a ball, put the goo on your finger and place your finger against the disks while pressing the prime button.

BTW, you need the warp to turn 1/4 of a turn with paint.

[Plasma69]

hmmmmmmmmmm............

ok thanks.
BUT let me ask you this. hmm.... by having unno paint goo on the disk, won't that goo contaminate the rest of my balls, than further into my gun and onto my barrels which in turn would get me GROSS accuracy? hehe... as you can tell, i dunno much. But thanks. i'll try that out.

anyone else care to help with the how to make the warp turn a tad more?

[hitech]

You don't want to use a lot. Just enough to oil the surface of the disks. Also, check your dwel l jumpers and increase the dwell if necessary/possible.

[Plasma69]

well

how do you set the dwell and stuff using the jumpers?? hehe... i don't have a manual. so any manuals online would be appreciated very much. thanks.

[RobAGD]

the basic manual is on www.airgun.com under the tech area I belive.

There are few timmy tricks you need to do with them when running Warps and Halos, you need to add an oring to the ram to push the bolt a tad bit more forward so that the pressure on the ball wont move it past the eyes.

Next you need more spin time and if using RPS Paints you need to goo the disk a tad like suggested above, you dont use a lot just a little to allow the clutching action needed to make teh warp run good.

-Robert

[Plasma69]

wow sweet

Thanks Rob! its all fixed and its ready to fire and kill next tourney!!!! again thanks so much!!!!! what an honor from the great rob! can't wait to try it out.... i'll get pix for you guys soon..... should see this BadA$$ setup!