Help With Barrel

[ITZMHECK]

Just got a dye boomstick for my emag, im having trouble inserting it into my gun.

[ITZMHECK]

Its getting like allt he way into the gun to about the second o ring. My old barell is going in but stillni need to like give it a budge. Any ideas?

[marley618]

Put some oil on your o-rings.

[ITZMHECK]

the gold pin seems to be holding it out any suggestions i already oiled it up

[ITZMHECK]

HELPPPPPPPPPPPPPPPPPPPP

[FrAuStY]

I had the same issue when I got my mag brand new, it took a while to break-in the barrel retaining pin. I took my gun apart and loosened the allen screw on the bottom of the pin. This allow it to mave in a litttle more since the spring was new. Once I broke the barrel in (You'll see a grey line in the slot on the barrel once the powdercoats worn off) I had to re-righten the spring otherwise the barrel would rotate and cause chops. You may just not be applying enough pressure to get it in..afraid to break it or something. Try this and see if it helps... keep an eye on your barrel and make sure it stays locked into place. If it starts unlocking then you'll need to tighten the screw back up. Good luck