I was intellifeeding my stock frame this week. Ground out the frame, got the parts, etc., all going well, until I decided to change the plan a little bit.
Instead of having that big, bulky connect hanging out the the middle of nowhere, I decided to make the connection on the side of the revvy. I used a enclosed, three-conductor panel mount phone jack and the cord from an old pair of 1/8" plug headphones. My question is, on the back of the jack package, it shows the numbered pin configuration and this:
Now, what does this mean, and how do I wire it?
Instead of having that big, bulky connect hanging out the the middle of nowhere, I decided to make the connection on the side of the revvy. I used a enclosed, three-conductor panel mount phone jack and the cord from an old pair of 1/8" plug headphones. My question is, on the back of the jack package, it shows the numbered pin configuration and this:
Now, what does this mean, and how do I wire it?
Comment