Intelliframe

[codeJockey]

I recently picked up an Intelliframe. Love it! One thing, though: there is a little over a 1/16" space between the back of the trigger & the tip of the sear pin when the 'Mag is gassed up. I'd like to snug it up a bit. I know that it's a big-bad to mess with the sear pin length, but it seems like the only way to get rid of the space. Any help would be great...

[FreshmanBob]

i have the same problem on my micromag, i'm also not sure if that would throw things off

[virus]

the space is supposed to be there... if you put a stock frame or even the Zgrip this space will be there also....

remember the trigger on the mag is nothing more then a hooked piece hanging from a pivot point.... in one really wanted to you could take the trigger out completely and operate the sear rod that way.... but your finger will tire and have a nice indentation on it to boot.....

the only thing i would recomend if you really cant stand it that much would be to fashion a triger stop that would limit the forward travel of the trigger..... but remember to leave a small gap anyway... or the whole thing will be that much eaiser to short stroke ending up in more chopping and cleanin on the side instead of playin....

[drx975]