Warp Feed. Vibration sensor or direct link?

[Patron God of Pirates]

Hi, I'm new to the forums.

I recently purchased and Automag RT Pro with a power feed stock. After out firing my feed rate a few times a purchased a Warp feed.

Two questions:

1) Do I need an Intelliframe to wire my trigger direct to the warp feed, or can it be done with the stock grip/trigger?

2) Is it worth my while to do so (or by an intelliframe and do so) or does the vibration sensor work well enough?

Any other suggestions would be appreciated.

[Potatoboy]

Well, It will work on vibration, but it will be much more reliable with an intellifeed link.

You can wire the switch into the stock frame, but it requires some cutting of the frame and trial and error.

The intelliframe has screw holes exactly where you need to put the switch and is a good 2x trigger to boot.