How do you remove your Mag trigger?

[The Mag Man]

I have an Intelliframe and i'm wondering how I would go about removing my trigger for powdercoating purposes.

[BlackVCG]

Take a drift pin and knock out the trigger pin from the safety side of the frame. One side of the pin is knurled.

[FrAuStY]

As BlackVCG stated if you were holding the triggerframe like you'd shoot it.. tap pin from the right side to the left side. if you tap it more than 3/16" and don't see either knurling or like mine was smashed on two sides to make it look like this =O= . Then you may want to tap other direction. Hope this helps.

[The Mag Man]

How would I put it back in then? And what would I "tap" the drift pin with? A hammer?

[echoes]

A related question... can AGD sell just the trigger for the intelliframe?

[The Mag Man]

Up!

[spazzed]

I'm in the same boat, I'm having problems getting the trigger pin back in. Anyone got any hints?

[FreshmanBob]

loctite!

[spazzed]

uhhh... no.

[FreshmanBob]

no really, if your having trouble getting the pin back in tightly, put a little bit of loctite on the side that goes in last. It might work, im not sure but use a lower strength one just incase