warpfeed

[roczilla]

[FrAuStY]

I believe you can use a barrel (old one preferably) to make the indentation on the hopper. I think in the instructions you get with your warp it even states to use a barrel since most are the same size outside diameter as the warp hose. If you don't want to do that.. get a piece of 1" diameter conduit and use that. I got away without melting the hopper

[Army]

Cutting two holes in the hopper, for the hose to pass through, is also a popular way to go. It is also easier, and less likely to get messed up. Besides that, you only have to plug the holes when you use the hopper on another gun, keeping the total volume. When you melt in, you will lose the 5-7 balls forever.

[Shail]

I got a ricochet on my warp and because of its shape I didnt have to modify it at all, but using a barrel to indent the hopper,as previously stated, works good, as I'm told.

[sniper1rfa]

well, i used a heat gun. just heat it till something starts bubbling and then press the barrel in and hold it there. i have seen people use lighters, but that is time consuming and wont look nice.