Question about Macro line

[Timrevo13]

Unfortunetly i currently have my minimag running on co2 , i threw an Xchamber on there to try and help the scene a little. Everything is Macro line but it seems to want to leak from all the elbows where the macro line goes in. Anybody have and suggestions?

[Xen]

take the line out and check to see if it is a straight edge at the end of the fitting. Also see if there are a lot of wear / marks around where the line fits in the fitting. hope this helps

[Timrevo13]

okay

thanks ill do that

[Bartleby]

a good idea would be to apply a tiny bit of gun oil to the end of the macro line where it enters the fitting. this will ensure a tighter fit. if that doesn't work you may want to consider making a new cut on the line so that the fitting can properly recreate a groove on the end of the line.

the last one always works for me.