warp feed

[Team_Psycho]

I just ordered a warp feed device online the other day. It came and is not functioning properly. The sensitivity dial is non-functional. The dealer told me to get a hold of AGD first. Can somebody please help? Thanks

[FrAuStY]

Did you follow the run-in procedure? Install a 9v battery, turn the dial fully clockwise until the warp runs on its own.. back it down just a hair (the warp will still run)Let it run for several minutes (I drained a 9v)Then you should be ready to go. Are the four dwell jumpers installed all horizontally?
[__] [__]
[__] [__]
like that when the warp is sitting as it would be mounted? I didn't really mess with mine all that much but I'm pretty sure these have to be in this storage config inorder for you to do the runin process. I could be wrong, but hey you could try it :) Also make sure the jumper set on the right is on the bottom.
oo
oo
[__]
Good luck...

[Team_Psycho]

I tried to follow the "run in procedure", but when I tried to adjust the sensitivity dial, the unit never ran. This evening after I returned home I tried again with 3 more fresh 9 volt batteries. The same problem. The dial is not working.

[a_malfunction]

Does it run when you press the white primer button?

[Team_Psycho]

yes