Is the ANS Phase II Valve and Venturi Bolt for the RT or other mags?

[JACE]

I'm having a problem with the accuracy of my RT, I just purchased it on e-bay. After about 30 ft the balls fly off in all directions, why is that? I'm thinking that it could be the stock bolt, that's why I asked about the Venturi Bolt and Phase II valve.

[than205]

Sounds like your having a paint to barrel match problem. Or is the paint anchient or bought from Walmart. (there anchient)

The bolt can be used on any Automag, I believe.
The valve would only go on a regular mag. The valve doesnt really do anything anymore.

[BlackVCG]

Welcome to the forums.

Look around and you'll learn a lot about Mags really quick. Searching for info on your RT is very simple and you can come up with lots of useful info.

First of all, the Phase II AIR valve only fits Classics, Minimags and Automags. Regardless, it's a useless part to buy. It will not improve the performance of your gun.

The bolt will work on the RT, but they are not built to AGD specs, so they end up wearing faster than the stock bolt.

What you need to do is make sure you're using good quality paint and make sure your barrel is well cleaned and dry. Also, make sure that the wire nubbin (detent) in the barrel is intact and not bent or broke in any way.

What I would recommend is going to the AGD Online Store and ordering the plastic nubbins and the foamie bolt. The foamie bolt is an AGD bolt that is a bit easier on paint.

Try these things out and let me know the results.

[RobAGD]

Also make sure your velocity isnt over 300fps, the faster you push a ball the more wacky it acts.

-Robert