Body Cutting (down to Warp size)

[keiphers]

I'm thinking of cutting my Powerfeed Right Minimag body down to a Warp feed sized body. How should I go about doing this? Should I get it professionally done?

[Will Wood]

try to connect the warp to where your plug is now, and then cut down the top of it so the plug will fit in so the balls will run thru smoothly.

[Will Wood]

Or this

Or you could get this, it would cost more, but you wouldn't have to mess with your gun.

http://www.proteamdirect.com/warfeedad.html

[Bartleby]

just measure the size of the current short side and then cut the other side down. i've done it three times, soon to be four, and had no issues.

in terms of how to do it, use a hack saw and then file down the edges to smooth them out. that's it.

[keiphers]

Thanks.

[Wheelman]

Will Wood

Yes he could do that, but I don't know why he would, I have that adaptor on mine and it greatly increases your profile, best bet would be to go under gun (where mine is going soon.)

[Thordic]

If you have one of those big composite-blade saws, you can do it in about half a second

Tunaman did mine for me, I think it took him all of 3 minutes. I cringed when be brought the arm down, but I tell you, he cut it as perfectly as I could ask for.

[Havoc_online]

The feedtube has to be 1.6 inches long to get the proper ball stack to feed right but remember that if you mess it up, there goes a whole body .

[Bartleby]

just cut it little by little if you're worried about it. i cut mine three times before i got it to the proper lenght. just remember, you can always cut it more, you just can't put back what's already been cut off.

[Wheelman]

man I cut it three time and the damn thing was still too short!