Question about the on/off assembly

[Ghost]

I recently purchased a MicroMag. When I put compressed to the gun everything is fine at first. The pin gains tension and presses against the trigger. I can hear no leaks of any kind. The gun will fire once or twice then loses all pressure. When I take out the valve and bolt I can see that the On/Off assembly has worked its way out past the O-ring.

I am hoping someone can help me figure out why the assembly is not staying within the proper slot. All the O-rings are in place and look brand new to me. The On/Off pin does not seem to move very freely. I have been out of paintball for a year or so and can't remember how that pin should feel as far as friction is concerned.

I appreciate any input that I may receive.

[virus]

a couple drops of oil will go a long way.... put it right in the air line the gas her up and fire (with out barrel) 10-20 times to work in through... this should do it

also this could be boltstick... to see if it is recreate the problem then take a stick squeegee or simlar item and push the bolt back (need to do with barrel on).... if the trigger rod resets then you'll need a spacer kit.... the directions for using it are right on the package

[Ghost]

Thank You, Ill try that.

[FrAuStY]

Not sure if you've tried this.. hold the trigger down when gassing up the gun. This shoudl keep the on/off from sliding out. Also the powertube spacers come in handy!