Sear Beveling

[1105]

anyone ever try or heard of this? i think i might try it but with my luck i'll mess up and have to my a new sear

[xmetal2001]

dont touch your sear

[1105]

haha oops too late dont know if its going to work right or not cause i dont have any air in my tank... i'll try it tomorrow, its supposed to give a softer, less abrupt trigger pull

[1105]

i just tried it out (using friends CO2 cause i have no nitrogen) and it seemed quiet a bit lighter... i still need to polish the top of the sear to have everything done... so far it shoots the same just a lighter trigger pull but i only fired a few shots so i'll have to see how it holds up after a few games

[xmetal2001]

Im pretty sure that over time it will now wear down faster and you'll probably have to replace it soon. But if its lighter now, and nows not then. Nifty.



i lost myself

[1105]

yes it does wear down the sear faster and your right, now is now... i'll worry about the sear when it doesnt work anymore... then i'll just get a new one and do the same thing

[rikkter]

matr of fact one of my teammates was talking about this to me today..he bevels his and it makes a cleaner lighter pull on the trigger.. im'a give him my sear and have him to it to mine :_

[Xzion]

Hope ya have money to burn, because buying new bolts and sears can get expensive, those mods will chew up both over time, AGD makes a special point of curving the tip of the sear that catches the bolt to help prevent wear, but with the polishing and beveling, all that goes out the window. Good old Ravi and his ways to mess up a mag. (im presuming you found these trigger mods on his website?)